HP Pavilion zt1200 HP Pavilion ze1200 and xf300 Series Notebook PCs - Troubles - Page 36

Removing the Hard Disk Tray, Reassembly Notes

Page 36 highlights

Screws, M2.5x4mm (2) Screws, M2.5x4mm (2) Figure 9. Removing the Hard Disk Tray Reassembly Notes • Insert the connector end of the drive through the opening in the carrier, then lower the drive into place. • Carefully slide the new drive into the hard drive compartment. Press firmly to make sure its connector seats properly. Important If you are installing a new hard disk drive, install the factory software and operating system on the drive before loading any additional software-see "Recovering the Factory Software Installation" on page 33. 36 Removing and Replacing Parts ze1000 Series Troubleshooting and Self-Repair Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

36
Removing and Replacing Parts
ze1000 Series Troubleshooting and Self-Repair Guide
Figure 9. Removing the Hard Disk Tray
Reassembly Notes
Insert the connector end of the drive through the opening in the carrier, then lower the drive into
place.
Carefully slide the new drive into the hard drive compartment. Press firmly to make sure its
connector seats properly.
Important
If you are installing a new hard disk drive, install the factory software and operating system on the
drive before loading any additional software
see
Recovering the Factory Software Installation
on page 33.
Screws,
M2.5x4mm (2)
Screws,
M2.5x4mm (2)