HP ProDesk 400 G5 Micro Maintenance and Service Guide - Page 52
Fan-sink, Loosen the four slotted Torx-15 captive screws
![]() |
View all HP ProDesk 400 G5 Micro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Fan-sink NOTE: The fan-sink spare part kit includes replacement thermal material. Follow these steps to remove the fan-sink: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 31). 2. Remove the access panel (see Access panel on page 32). 3. Remove the front bezel (see Front bezel on page 35). 4. Remove the drive cage (see Drive cage on page 36). Remove the fan-sink: 1. Disconnect the fan-sink cable (1) from the system board. 2. Release the power supply P3 cable from the two retention clips (2) built into the fan-sink. 3. Loosen the four slotted Torx-15 captive screws (3) that secure the fan-sink to the computer chassis. NOTE: Due to the adhesive nature of the thermal material located between the fan-sink and the processor, it may be necessary to move the fan-sink from side to side when removing the it. 4. Remove the fan-sink (4). Reverse this procedure to install the fan-sink. 46 Chapter 4 Removal and replacement procedures
![](/manual_guide/products/hewlettpackard-prodesk-400-g5-micro-maintenance-service-guide-04d2e03/52.png)