HP StorageWorks 8/8 Brocade Converged Enhanced Ethernet Command Reference v6.3 - Page 140
seq standard MAC ACLs, Synopsis, permit, count, no seq, Operands, permit or deny, Defaults, Command
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
8 seq (standard MAC ACLs) seq (standard MAC ACLs) Inserts a rule anywhere in the MAC ACL. Synopsis seq value {deny | permit} {any | host MAC _ACL| MAC_ACL} [count] no seq value Operands value Specifies the sequence number for the rule. The range of valid values is 0-65535. permit or deny Specifies rules to permit or deny traffic. any Specifies any source MAC address. host MAC_ACL Specifies the source host MAC address for which to set permit or deny conditions. Use the format HHHH.HHHH.HHHH. MAC_ACL Specifies the source host MAC address for which to set permit or deny conditions. Use the format HHHH.HHHH.HHHH. count Enables the counting of the packets matching the rule. Defaults By default, no MAC ACLs are configured. Command Feature Access Control List Configuration mode Modes Description Use this command to configure rules to match and permit or drop traffic based on source and destination MAC address and protocol type. You can also enable counters for a specific rule. There are 255 ACL counters supported per port group. Use the no seq value command to remove a rule from the MAC ACL. Usage There are no usage guidelines for this command. Guidelines Example To create a rule in a MAC standard ACL to permit or to drop traffic from the source MAC address 0022.3333.4444 and to enable the counting of packets: switch(conf-macl-std)#seq 100 deny 0022.3333.4444 count switch(conf-macl-std)#seq 1000 permit 0022.3333.4444 count To delete a filter rule in a MAC standard ACL: switch(conf-macl-std)#no seq 100 See Also deny, permit, resequence 122 Converged Enhanced Ethernet Command Reference 53-1001347-01