HP StorageWorks 8/8 Brocade Fabric OS Message Reference guide v6.2.0 (53-10011 - Page 177
EM-1061, Severity, Message, Probable Cause, Recommended, Action, haSyncStart
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
17 EM-1061 Severity WARNING EM-1061 Message , [EM-1061], ,, WARNING, , Synchronization halted. Remove all blades of type or upgrade your standby CP, then reboot or run haSyncStart. Probable Cause Indicates a blade in the system is not supported by the release on the standby control processor (CP). Recommended Action Remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will remain out of synchronization. Severity WARNING EM-1062 Message , [EM-1062], ,, CRITICAL, , Blade in slot faulted as it exceeds the maximum support limit of blades with Blade ID in the chassis. Probable Cause Indicates too many blades of a particular type are in the system. Recommended Remove the faulted blade. Action Severity CRITICAL EM-1063 Message , [EM-1063], ,, CRITICAL, , Blade in slot faulted because it exceeds the maximum support limit of blades with Blade IDs in the chassis. Probable Cause Indicates too many blades of a set of particular types are in the system. Recommended Remove the faulted blade. Action Severity CRITICAL EM-1064 Message , [EM-1064], ,, CRITICAL, , Blade: is being powered off (based on user configuration) upon receiving a HW ASIC ERROR, reason:. Fabric OS Message Reference 119 53-1001157-01