HP StorageWorks 8/8 Brocade Fabric OS Message Reference guide v6.2.0 (53-10011 - Page 211
FCPD System Messages, FCPD-1001
View all HP StorageWorks 8/8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Chapter FCPD System Messages 25 FCPD-1001 Message , [FCPD-1001], ,, WARNING, , Probing failed on . Probable Cause Indicates that a Fibre Channel Protocol (FCP) switch probed devices on a loop port, and probing failed on the L_Port, or AL_PA address, or the F_Port. For the AL_PA, the valid range is 00 through FF. The error string can be either of the following: • L_Port port_number ALPA alpa_number • F_Port port_number Recommended This can happen when the firmware on the device controller on the specified port has a defect. Action Check with the device vendor for a firmware upgrade containing a defect fix. Severity WARNING FCPD-1002 Message , [FCPD-1002], ,, WARNING, , port , bad R_CTL for fcp probing: 0x Probable Cause Indicates that the response frame received on the specified port for an inquiry request contains an invalid value in the routing control field. Recommended This can happen only if the firmware on the device controller on the specified port has a defect. Action Check with the device vendor for a firmware upgrade containing a defect fix. Severity WARNING FCPD-1003 Message , [FCPD-1003], ,, INFO, , Probing failed on which is possibly a private device which is not supported in this port type Probable Cause Indicates that private devices will not respond to the switch port login (PLOGI) during probing. Recommended Action The Brocade DCX, 4100, 4900, 5000, 7500, and AP 7600 do not support private loop devices. Refer to the switch vendor for a list of other port types that support private devices for inclusion into the fabric. Severity INFO Fabric OS Message Reference 153 53-1001157-01