HP Stream 11-r000 Maintenance and Service Guide - Page 59
until it rests at an angle., by sliding it up and to the left at an angle.
View all HP Stream 11-r000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
4. Disconnect the speaker cable (4) from the system board. 5. Remove the four Philllips PM2.0×3.3 screws (1) that secure the system board to the bottom cover. 6. Release the system board by lifting the left side of the system board (2) until it rests at an angle. 7. Remove the system board (3) by sliding it up and to the left at an angle. Reverse this procedure to install the system board. Component replacement procedures 51
4.
Disconnect the speaker cable
(4)
from the system board.
5.
Remove the four Philllips PM2.0×3.3 screws
(1)
that secure the system board to the bottom cover.
6.
Release the system board by lifting the left side of the system board
(2)
until it rests at an angle.
7.
Remove the system board
(3)
by sliding it up and to the left at an angle.
Reverse this procedure to install the system board.
Component replacement procedures
51