HP Visualize c3000 hp Visualize c3600 UNIX workstations PA8600 upgrade instruc - Page 20

Removing the Power Supply

Get HP Visualize c3000 - Workstation PDF manuals and user guides View all HP Visualize c3000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

System Board Removal/Replacement Removing the Power Supply Figure 2-3 Removing the Power Supply 1. Position the workstation on its side so the power supply label is facing you. It is best to use a cushioned surface to protect the exterior of the system from damage. 2. Position the conductive sheeting so that an inch of one edge is under the workstation and the rest is flat against the work area to lay system components on after you remove them. Also ensure that your static-grounding strap is securely attached to your wrist and to bare metal on the workstation. Power Supply Screws and Handles T15 Torx Thumbscrew Power Supply Handle T15 Torx Thumbscrew 3. Alternately loosen the two T-15 Torx screws from the corners of the power supply as shown above. 4. Using the handle, lift up the power supply and place the bail in the bail lock to hold the power supply upright. 20 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
20
Chapter 2
System Board Removal/Replacement
Removing the Power Supply
Removing the Power Supply
1.
Position the workstation on its side so the power supply label is facing
you. It is best to use a cushioned surface to protect the exterior of the
system from damage.
2.
Position the conductive sheeting so that an inch of one edge is under
the workstation and the rest is flat against the work area to lay
system components on after you remove them. Also ensure that your
static-grounding strap is securely attached to your wrist and to bare
metal on the workstation.
Figure 2-3
Power Supply Screws and Handles
3.
Alternately loosen the two T-15 Torx screws from the corners of the
power supply as shown above.
4.
Using the handle, lift up the power supply and place the bail in the
bail lock to hold the power supply upright.
T15 Torx
Power Supply
Thumbscrew
Handle
T15 Torx
Thumbscrew