HP Visualize c3000 hp Visualize c3600 UNIX workstations PA8600 upgrade instruc - Page 36
Reinstalling the Air Divider
View all HP Visualize c3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
System Board Removal/Replacement Reinstalling the Air Divider Figure 2-16 Reinstalling the Air Divider 1. Slide the air divider into the workstation. 2. Replace the two T-15 Torx screws-one on the back and one on the side-that secure the air divider to the chassis. 3. Replace the PCI retainer clip by inserting its bottom end into the hole in the air divider, and then pushing upward and inward-making sure that all the PCI cards' edges are aligned properly with the individual retainers on the clip-until the clip clicks into place against the top panel of the chassis. (The purpose of the air divider is to keep the airflow that cools the PCI I/O cards separate from the airflow that cools the system board; without the air divider, the cooling of the components would be insufficient.) Installing the Air Divider PCI Retainer Clip T-15 Torx Thumbs Air Divider 36 Chapter 2