HP Workstation x1100 hp workstations general - hp ultra 160 RAID install and r - Page 10

Installing HP Ultra 160 RAID and Migrating Your File System Installation and Migration Process License Agreement, follow the instructions to create a Symbios (symc 1010) driver diskette. NOTE From the DOS prompt, you must change directories to the makedisk directory on the CD-ROM drive to run the makedisk command. For NT 4.0: makedisk WINNT SYMC1010. For Windows 2000: makedisk WIN2K SYMC1010. Leave the diskette in the drive. NOTE Save this driver diskette as it also contains software that is useful during recovery procedures. b. For Windows NT 4.0, close the Nextreme browser window and open the Windows NT SCSI Adapter Control Panel. Select the drivers tab, click the add button and click the have disk button: In the input line that appears, type: A:\winnt\miniport Then follow the defaults until you are asked to restart the system. At this screen, select NO. Remove the Nextreme RAID CD-ROM and the driver diskette and shut down the system. For Windows 2000, the operating system will detect the new adaptor and request a driver update. NOTE HP recommends that you leave the Adaptec SCSI driver installed until you have booted to the hard drive attached to the Symbios SCSI card. c. After the system powers itself off, unplug the power cord from the back of the chassis. Step 3. Install the SYM21040 Board and additional Hard Disk Drive. NOTE: Observe proper anti-static procedures before removing the existing Adaptec® 29160 SCSI Controller board from your Workstation. 10 Chapter 1