HP Workstation x1100 hp workstations general - hp ultra 160 RAID install and r - Page 13

NOTE Installing HP Ultra 160 RAID and Migrating Your File System Installation and Migration Process Log-in with Administrator privileges. h. Go to the Windows NT SCSI Adapter Control Panel and select the driver tab. Highlight the Adaptec 29160 driver and click the remove button. Select the defaults and close the Control Panel window. Windows 20000 is plug and play and you will not need to delete the adaptec driver. Step 4. Install the Nextreme RAID software. a. Re-insert the Nextreme CD-ROM and allow it to Auto-Run. The Nextreme introduction screen will appear. In the Contents section on the right, click on: Nextreme Migration. You will have to install three utilities in the following order: Runtime Environment, Migration Utility and Veritas® Array Manager. b. Near the bottom of the page, click on: Install Nextreme Migration Utility's Runtime Environment. Select: Run this program from its current location and click OK. If you get an authenticode signature not found message, click YES to install and run the utility. Select the remaining defaults until you are returned to the Nextreme Migration Setup browser screen. c. Again (near the bottom of the page), click on Install Nextreme Migration Utility. Choose: Run this program from its current location and click on OK. If you get an authenticode signature not found message, click YES to install and run the utility. Select the remaining defaults until you are returned to the Nextreme Migration Setup browser screen d. Click on the Back button in the browser. In the Content area on the right, click on: Veritas Array Manager, scroll down and choose: 1. Choose Veritas Array Manager for Windows NT 4.0 if using NT 4.0. Choose Run this program from its current location and select OK. Select the remaining defaults. Chapter 1 13