HP Workstation x1100 hp workstations general - hp ultra 160 RAID install and r - Page 15

Step 6. Modify drive letters., Assigning proper drive letters

Get HP Workstation x1100 PDF manuals and user guides View all HP Workstation x1100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

CAUTION Figure 1-3 Installing HP Ultra 160 RAID and Migrating Your File System Installation and Migration Process begin the migration. c. Press enter when prompted NOTE: This step can take more than one hour to complete for disk striping. For mirroring, it will only take a few seconds but you should wait until system progress shows all disk mirroring is complete. When migration is complete, remove the Nextreme CD-ROM and press any key to re-boot. Step 6. Modify drive letters. You must now use the Veritas® console to assign the proper drive letters to the two disk drives. To modify them, select the Start button on the task bar, then Programs, Veritas Array Manager and Console. Be careful not to choose Uninstall Veritas Array Manager software in the Veritas Array manager menu. It will shut down the Disk Management Service first and then ask for confirmation. If you inadvertently make this choice, you will have to re-start Disk Management Service from the Windows NT Services Control Panel. Click on: Volumes Right Click on: the CD-ROM icon named "D" Select: Modify Drive Letter (see Fig. 1-3) and change the CD-ROM drive letter to "E." Assigning proper drive letters Chapter 1 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Installing HP Ultra 160 RAID and Migrating Your File System
Installation and Migration Process
Chapter 1
15
begin the migration.
c.
Press enter when prompted
NOTE: This step can take more than one hour to complete for disk
striping. For mirroring, it will only take a few seconds but you should
wait until system progress shows all disk mirroring is complete.
When migration is complete, remove the Nextreme CD-ROM and press
any key to re-boot.
Step 6. Modify drive letters.
You must now use the Veritas® console to
assign the proper drive letters to the two disk drives. To modify them,
select the Start button on the task bar, then Programs, Veritas Array
Manager and Console.
CAUTION
Be careful not to choose Uninstall Veritas Array Manager software in the
Veritas Array manager menu. It will shut down the Disk Management
Service first and then ask for confirmation. If you inadvertently make
this choice, you will have to re-start Disk Management Service from the
Windows NT Services Control Panel.
Click on:
Volumes
Right Click on: the CD-ROM icon named “D”
Select:
Modify Drive Letter
(see Fig. 1-3) and change the CD-ROM
drive letter to “E.”
Figure 1-3
Assigning proper drive letters