HP Z210 HP Workstations - CRU Dataport DX115 kit installation - Page 13
HP Z600 and Z800 computers, CAUTION,
View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
4. Install one (supplied) 6-32 x 1/4 in. screw (silver) for each DX115 unit for shipping support. CAUTION: Failure to install the shipping screw might result in damage to the removable hard drive system. Figure 21 Installing the shipping support screw HP Z600 and Z800 computers 1. For HP Z800 computers: ● Remove the airflow guide to enable access to the optical bays. ● Remove the card support to enable access to the system board connectors. 2. Remove and discard the counter-sunk shipping screw at the side of the DX115 case. Figure 22 Removing the shipping screw 3. Lift and hold the drive release latch at the green touch point (1) while sliding the DX115 case into the bay (2). When the front of the drive is near its final position, release the latch, but continue to slide the drive inward until the latch closes and engages the drive. Figure 23 Installing the DX115 case ENWW Step 2-Installing the DX115 case into the optical drive bay 13