HP Z210 HP Workstations - CRU Dataport DX115 kit installation - Page 18
Step 4-Completing the computer assembly, CAUTION,
View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Step 4-Completing the computer assembly CAUTION: Insert or remove the carrier (with a disk drive) only when the workstation is shut down. Other procedures may result in system hangs, data loss, or even drive damage. The component supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the workstation is booted and then powering the drive via the power switch on the enclosure. Microsoft Windows XP and Windows Vista do not support this action. 1. After the drive case is installed in the computer, insert the drive carrier into the case. a. Press on the left side of the handle (1) to open the door. b. Insert the drive carrier. c. If shipping or moving the computer, lock the carrier by inserting the key (2) and turning it counterclockwise (3). CAUTION: Always lock the drive before shipping or moving the computer. Failure to do so might result in damage to your removable hard drive system. Figure 33 Locking the carrier 2. Connect the power (1) and data (2) cables to the primary (upper) ports on the unit. Figure 34 Power and data ports 18 CRU Dataport DX115 kit installation ENWW