HP Z6100 HP Designjet Z6100 Printer Series - Setup Poster (60 inch) - Page 12

75 Plug the power cable into the rear of the printer, and then plug the other end into the AC power outlet. 76 Turn the Power switch to the On position at the rear of the printer. 77 If the power light on the front panel remains off, press the Power button to switch on the printer. 78 Wait until this message appears on the front panel (~1 minute). Use the Up and Down buttons to highlight the language you want, and then press the OK button. 1' 79 Wait until this message appears. The front panel guides you through the procedures for inserting the ink supplies. 80 To release the ink cartridge drawer, gently pull down on the blue handle, and then slide out the ink cartridge drawer. 81 Shake the ink cartridge vigorously for about 15 seconds. Be careful not to strike it against any surface because this can damage the cartridge. Page 12 82 Place the ink cartridge in the ink cartridge drawer. The arrow on the front of the ink cartridge should point upwards. Note that there are marks on the drawer to show the correct location to place the cartridge.