HP Z6100 HP Designjet Z6100 Printer Series - Setup Poster (60 inch) - Page 9
Remove the two take-up reel hubs. - spindle
 |
UPC - 882780989535
View all HP Z6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
53 Connect the sensor cable to the rear of the take-up reel motor. Connect the sensor cable to the sensor unit located on the right foot. 54 Use the clips provided to attach the sensor cable to the lower cross-brace. 55 Remove the take-up reel deflector from the box. x5 56 Attach the take-up reel deflector by inserting the left side of the deflector into the left deflector support, and then inserting the right side of the deflector into the right deflector support. 57 Carefully lift the central core tube. The central core tube contains the take-up reel spindle. 58 Remove the take-up reel spindle from the core. 59 Remove the two take-up reel hubs. 60 Loosen the plastic nut on the black hub. Page 9
-
1 -
2
-
3
-
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
 |
 |
Page 9
x5
53
Use the clips provided to attach the sensor cable
to the lower cross-brace.
54
Remove the take-up reel deflector from the box.
55
Attach the take-up reel deflector by inserting the
left side of the deflector into the left deflector
support, and then inserting the right side of the
deflector into the right deflector support.
56
Carefully lift the central core tube. The central
core tube contains the take-up reel spindle.
57
Remove the take-up reel spindle from the core.
58
Remove the two take-up reel hubs.
59
Loosen the plastic nut on the black hub.
60
Connect the sensor cable to the rear of the
take-up reel motor.
Connect the sensor cable to the sensor unit
located on the right foot.