HP Z6100 HP Designjet Z6100 Printer Series - Setup Poster (60 inch) - Page 7
Assemble the take-up reel - take up reel
UPC - 882780989535
View all HP Z6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Assemble the take-up reel Steps 38 to 68. This task requires 1 person. Time required is 35 minutes. 35' x1 Boxes required 38 Identify the four holes on the inside of the right leg. The holes are used to attach the take-up reel motor. 39 Locate the bag of screws that is included in the take-up reel box. 40 Insert two screws into the two forward holes. Leave sufficient space between the screw heads and the leg to attach the take-up reel motor. x2 41 Attach the take-up reel motor to the two screws, and then pull the take-up reel motor down so that it rests securely on the screws. 42 Use two screws to attach the rear of the take-up reel motor to the stand, and then tighten all four screws. x2 43 Use the parallel plug to connect the take-up reel motor to the parallel port at the rear of the printer. Page 7 44 Identify the three holes on the inside of the left leg. The holes are used to attach the left side of the take-up reel assembly.