HP dx2818 Hardware Reference Guide - dx2818 Microtower Model - Page 40
Installing the Hard Drive in the Drive Cage, Installing, Additional Drives,
View all HP dx2818 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
2. Slide the new drive into the hard drive cage (1), aligning the drive with the four screw holes on the cage. Install the four 6-32 standard screws that secure the hard disk drive to the hard drive cage (2). Make sure the hard disk drive cables are facing the top of the drive cage. NOTE: If you are replacing an old drive with a new drive, use the four retainer screws from the old drive to install the new drive. NOTE: If you are installing a second hard drive, use four of the extra standard 6-32 screws that are installed on the interior of the front bezel. The 6-32 screws are silver. Refer to Installing Additional Drives on page 23 for an illustration of the retainer screws location. Figure 2-30 Installing the Hard Drive in the Drive Cage 34 Chapter 2 Hardware Upgrades ENWW