HP t420 Troubleshooting Guide - Page 13
Replacing the access panel
View all HP t420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Replacing the access panel To replace the access panel: 1. Align the tabs on each side of the access panel with the slots in the chassis. Set the access panel on the chassis, approximately 6 mm (.24 in) inside the edge of the chassis, and then slide the panel toward the front of the chassis (1) into place. 2. Fasten the two screws into the ends of the back I/O panel to secure the access panel (2). Removing and replacing the access panel 7
Replacing the access panel
To replace the access panel:
1.
Align the tabs on each side of the access panel with the slots in the chassis. Set the access panel on the
chassis, approximately 6 mm (.24 in) inside the edge of the chassis, and then slide the panel toward the
front of the chassis (1) into place.
2.
Fasten the two screws into the ends of the back I/O panel to secure the access panel (2).
Removing and replacing the access panel
7