HP t420 Troubleshooting Guide - Page 16
Replacing the USB 3.0 flash drive, flash
View all HP t420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Replacing the USB 3.0 flash drive WARNING! Before removing the access panel, be sure that the thin client is turned off and the power cord is disconnected from the electrical outlet. To Install the USB 3.0 flash drive, perform the following steps: 1. Lay the thin client down with the right side up. 2. Remove the thin client access panel. See Removing the access panel on page 6. 3. Locate the USB 3.0 flash drive holder on the system board. 4. Lift the USB holder and push it forward to expose the USB socket. 5. Slide the USB 3.0 flash drive firmly into the USB socket (1). 6. Push the USB holder back and press it down (2) to lock the USB 3.0 flash drive in place. 7. Replace and secure the access panel. See Replacing the access panel on page 7. 10 Chapter 2 Hardware changes