Hitachi CP-X2 User Manual - Page 10
Using a USB storage, Using an SD card - wireless
![]() |
UPC - 050585151079
View all Hitachi CP-X2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Setting up Using a USB storage In order to view images stored in a USB storage, such as a USB memory, insert the device into the USB STORAGE port. Before removing the USB storage, be sure to perform the REMOVE procedure using the SERVICE menu under the MIU menu. (54) Using an SD card SD card slot cover In order to view images in an SD Memory Card (SD card), insert the card into the SD card slot. If the wireless network function is required, load the internal clock battery (58) and insert the enclosed Wireless network card (SD card) in to the SD card slot. SD card slot SD CARD SD card slot Inserting an SD card 1. Make sure that the power code is not plugged into the projector. 2. Remove the SD card slot cover. It might be recommended to hook the edge of its side face up to remove it. SD card Angled corner 3. Slowly insert the SD card completely into the SD card slot. Make sure that the angled corner of the SD card is placed into the right side of the SD card slot, while inserting. SD CARD SD CARD 4. Replace the SD card slot cover. It is recommended that the cover is slid sideways to the projector. Using the slot cover lock for security Using the enclosed slot cover lock can prevent the SD card slot cover from being opened. 1. Open the two plates of the slot cover lock to put the tips of two plates together, and then insert the tips to the lock hole of the SD card slot cover. 2. Put the body of the two plates together. Then, hook a padlock or combination lock to the hole of the slot cover lock. Removing the SD card When removing "wireless network card", turn the projector off and unplug the power cord. On the other hand, when removing the "SD Memory Card", be sure to perform the REMOVE procedure using the SERVICE menu under the MIU menu. (54) NOTE • When using the projector with a wired LAN, please remove the wireless network card. IMPORTANT NOTE • To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. • When using wireless network card, please make sure to put the SD card slot cover onto projector top case to protect the card from electrostatic discharge influence. 10
![](/manual_guide/products/hitachi-cpx2-user-manual-37f4407/10.png)