Hitachi DV-S522U Owners Guide - Page 10

Antenna Connections

Get Hitachi DV-S522U PDF manuals and user guides View all Hitachi DV-S522U manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Antenna Connections CAUTION: When installing an outdoor antenna, follow the installation instructions in the attached "IMPORTANT SAFETY INSTRUCTIONS". FM outdoor antenna (not supplied) AM loop antenna Antenna discharge unit (not supplied) FM indoor antenna lead wire FM 75Ω 75-ohm coaxial cable (not supplied) AM LOOP FM antenna The FM indoor antenna lead wire is sufficient to receive most local FM broadcasts and should be connected to the rear FM 75Ω terminal. Extend the antenna lead wire as straight as possible and, while listening to the sound from the system, secure it in a position where the best FM reception is found. In fringe areas, or where reception is distorted or noisy, an FM outdoor antenna (not supplied) should be connected instead of the FM indoor antenna lead wire. The terminals will accept 75ohm coaxial cable. AM antenna The AM loop antenna is sufficient to receive most local AM broadcasts. 1 2 Assemble the loop antenna. Unwind the antenna wires, then connect them to the AM LOOP terminals. Place the loop antenna in a position which yields the best AM reception, or attach it to a wall or other surface as shown. 1 3 2 NOTE: Screws (not supplied) To minimize noise... • Keep the speaker wires, power cord and all other system connection cables away from the loop antenna. • Do not place the antenna close to a TV or speaker. Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. ANT FM 75Ω AM LOOP VIDEO 1 VIDEO 2 VIDEO IN VIDEO OUT VIDEO IN AUDIO IN AUDIO OUT AUDIO IN L L R R COMPONENT VIDEO OUT Y CB/PB VIDEO OUT SELECT MONITOR OUT (DVD ONLY) S-VIDEO VIDEO (DVD ONLY) COMPONENT S-VIDEO CR/PR VIDEO OUT SCAN SELECT SELECTABLE INTERLACE R L FRONT CENTER R L SUB WOOFER SURROUND SPEAKERS 8Ω -E9-

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
-E9-
C
R
/P
R
C
B
/P
B
Y
COMPONENT
VIDEO OUT
R
L
VIDEO 2
VIDEO 1
ANT
FM
75
Ω
AM
LOOP
VIDEO IN
AUDIO IN
R
L
VIDEO IN
AUDIO IN
VIDEO OUT
AUDIO OUT
VIDEO
S-VIDEO
(DVD ONLY)
MONITOR OUT
R
L
CENTER
FRONT
R
L
SUB WOOFER
SURROUND
SPEAKERS 8
Ω
VIDEO OUT SELECT
(DVD ONLY)
S-VIDEO
COMPONENT
VIDEO OUT
SCAN SELECT
SELECTABLE
INTERLACE
FM
75
Ω
AM
LOOP
1
2
1
2
3
Antenna Connections
FM antenna
The FM indoor antenna lead wire is sufficient to receive most
local FM broadcasts and should be connected to the rear FM
75
Ω
terminal. Extend the antenna lead wire as straight as possible
and, while listening to the sound from the system, secure it in a
position where the best FM reception is found.
In fringe areas, or where reception is distorted or noisy, an FM
outdoor antenna (not supplied) should be connected instead of
the FM indoor antenna lead wire. The terminals will accept 75-
ohm coaxial cable.
AM antenna
The AM loop antenna is sufficient to
receive most local AM broadcasts.
Assemble the loop antenna.
Unwind the antenna wires, then
connect them to the AM LOOP
terminals. Place the loop antenna in a
position which yields the best AM
reception, or attach it to a wall or other
surface as shown.
NOTE:
To minimize noise...
•
Keep the speaker wires, power cord and all other system
connection cables away from the loop antenna.
•
Do not place the antenna close to a TV or speaker.
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s
attention to Section 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
Screws (not supplied)
FM outdoor antenna
(not supplied)
AM loop antenna
Antenna discharge unit
(not supplied)
FM indoor antenna lead wire
75-ohm coaxial cable
(not supplied)
CAUTION:
When installing an outdoor antenna, follow the installation
instructions in the attached “IMPORTANT SAFETY
INSTRUCTIONS”.