Hitachi FX77GII User Guide - Page 22

StarBoard FX-77GⅡ Board (4)(5) (6) (10) (3) Height Adjustment Introduction (a) Decide the level (out of six) at which the board will be installed, and use the square holes on the back of the board to hang it on the Height Adjustment Stay. (b) Verify that one of the board's square holes is attached securely to the Height Adjustment Stay on each side. (c) Tighten triangular knob screw to fasten the board to the board fixing bracket on each side. CAUTION Fully tighten the triangle head screw. The board might fall and cause injury or its impact might cause damage. This work should be performed by at least two people. The board might fall and cause injury or its impact might cause damage. The StarBoard can be positioned at six height levels. Adjust the height according to the following procedure. Furthermore, this work should be done by at least two people. (a) Remove the triangular knob screw at the bottom of each side. (b) Raise the board and re-hang it by (b) attaching the square holes for the desired © height to the Height Adjustment Stay . (a)(c) (c) Fasten the triangular knob screw at the bottom of each side. 1-11 English