Hitachi FXTRIO-88W User Guide - Page 26
Warnings, Caution
View all Hitachi FXTRIO-88W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
StarBoard FX-TRIO Series Introduction [2] Install the board WARNINGS Tighten the screws securely. Failure to comply may cause the board to fall, resulting in personal injury, or may cause damage to this product due to shock of impact from the board falling. CAUTION Be sure to use two or more people for this work. Failure to comply may cause the board to fall, resulting in personal injury, or may cause damage to this product due to shock of impact. Install the board on the stand assembled in step [1]. Install the board according to the following procedure. Note that this work should be performed by two or more people. The numbers in the diagram correspond to the numbers in the parts list on page 1-3 of this User's Guide. Board (4)(5) (a) Decide the level (out of six) at which the board will be installed, and attach the board receiving brackets (4) and (5) to the square holes of the stays on the back of the board. (6) (10) (b) Verify that the square holes are attached securely to the board receiving brackets on both sides. (c) Fix the board fixing brackets (6) temporarily on the stand vertical supports (1) using the pan head screws (9). (d) Tighten the triangular knob screw (10) to fasten the board to the board fixing bracket (6) on both sides. (e) Tighten the pan head screws that were fixed temporarily in (c). 1-12 English