Hitachi FXTRIO-88W User Guide - Page 38

StarBoard FX-TRIO Series How to use If the positions of the pen tip and cursor are out of alignment, select "MENU" on the StarBoard Software toolbar → "Settings" → "StarBoard"→ "Calibrate," and then perform position alignment. Important Conduct sensor adjustments upon first-time operations and whenever the board has been moved. Not doing so may cause operation errors. 2.3.2 Start Method (Mac version) (1) Connect the devices with reference to the connection method on page 1-16. (2) Turn on the power switch of the projector. (3) Turn on the power switch of the PC to start Mac (4) Adjust the position of the projector so that the Mac screen projected by the projector is within the input area (refer to page 1-5 of this User's Guide). (5) Select "Go" → "Applications" → "StarBoard Software" to start StarBoard Software. (6) Select "MENU" on the StarBoard Software toolbar → "Settings" → "StarBoard" → "Check Connection," and then check the connection. If the "StarBoard is not connected" message appears, StarBoard Software has not detected the StarBoard. Check whether the StarBoard and PC are connected properly. Connected No Connection If they are connected properly, the "StarBoard is connected" message appears. If the indication does not change even though you have checked the connection, there is likely to be some problem. For details, see "3. Appendix Troubleshooting " on page 3-1 in this user's guide. (7) Start "Go" → "Applications" → "Lsadrv" → "LsCamWiz," and then adjust the sensor in accordance with the procedure on page 3-6 2-8 English