Hitachi FXTRIO-88W User Guide - Page 30

Projector, Power Supply, StarBoard

Get Hitachi FXTRIO-88W PDF manuals and user guides View all Hitachi FXTRIO-88W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

StarBoard FX-TRIO Series Introduction 1.4.4 Equipment Connection Method Before Starting to Connect Equipment Install the StarBoard Software on your PC before starting to connect equipment. The equipment might not operate correctly if it is connected without the software being installed. Connect the PC, projector and StarBoard according to the following procedure. StarBoard Projector Power Supply (1) Connect the RGB cable to the projector's RGB connector, and fasten with screws. (2) Connect the opposite side of the RGB cable to the PC's RGB connector, and fasten with screws. (3) Connect the USB cable from the lower right of the StarBoard to a USB port on the PC. (4) Connect the power supply cables of the PC and projector to the power supply. About PC Earth Depending on your PC, an incorrect operation might be caused by PC noise via the USB cable. If this happens, verify that the earth of your PC's power supply cable is connected. If the earth is not connected, it might cause an incorrect operation. 1-16 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
1-16
StarBoard FX-TRIO Series
Introduction
English
1.4.4 Equipment Connection Method
Connect the PC, projector and StarBoard according to the following procedure.
(1) Connect the RGB cable to the projector's RGB connector, and fasten with screws.
(2) Connect the opposite side of the RGB cable to the PC's RGB connector, and fasten with
screws.
(3) Connect the USB cable from the lower right of the StarBoard to a USB port on the PC.
(4) Connect the power supply cables of the PC and projector to the power supply.
Depending on your PC, an incorrect operation might be caused by PC noise via the
USB cable. If this happens, verify that the earth of your PC's power supply cable is
connected.
If the earth is not connected, it might cause an incorrect operation.
About PC Earth
Install the StarBoard Software on your PC before starting to connect equipment. The
equipment might not operate correctly if it is connected without the software being
installed.
Before Starting to Connect Equipment
Projector
Power Supply
StarBoard