Honeywell 6272CSV User Guide - Page 26
Fire Alarm Operation, In Case of Fire Alarm, Silencing and Clearing a Fire Alarm
View all Honeywell 6272CSV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Security (Cont'd) Fire Alarm Operation Your fire alarm system (if installed) is on 24 hours a day, providing continuous protection. In the event of an emergency, the installed smoke and heat detectors will automatically send signals to your Control/Communicator, triggering a loud interrupted sound from the keypad. An interrupted sound will also be produced by optional exterior sounders. A FIRE message will appear at your keypad and remain on until you silence the alarm. In Case of Fire Alarm 1. Should you become aware of a fire emergency before your detectors sense the problem, go to your nearest keypad and manually initiate an alarm by pressing the panic key assigned as FIRE emergency (if programmed by the installer) and hold down for at least 2 seconds. 2. Evacuate all occupants from the premises. 3. If flames and/or smoke are present, leave the premises and notify your local Fire Department immediately. Silencing and Clearing a Fire Alarm 1. Silence, acknowledge, and clear the alarm by: a. For Residential Systems: Press "Touch here to Silence" on the display to silence the alarm. For Commercial Systems: Enter your code. This will silence and acknowledge the alarm and disarm the system (if armed). b. Press the CLEAR button followed by your code. This will acknowledge the alarm and disarm the system (if armed). c. Press the DISPLAY FAULTS button on the Arming screen. The faulted fire zone will be displayed. d. Press the CLEAR button and then enter your code. This will clear the Fire Alarm from the system. 2. If the keypad does not indicate a READY condition after the second sequence, press the DISPLAY FAULTS key on the Arming screen to display the zone(s) that are faulted. Be sure to check that smoke detectors are not responding to smoke or heat producing objects in their vicinity. In this case, eliminate the source of heat or smoke. 3. If this does not remedy the problem, there may still be smoke in the detector. Clear it by fanning the detector for about 30 seconds. 26