Honeywell 6272CSV User Guide - Page 27

Security (Cont'd) 4. When the problem has been corrected, clear the display by entering the DISPLAY FAULTS button on the Arming screen, selecting the fire zone, pressing the CLEAR button and then entering your user code. Note: Contact your Security Company for servicing if you have further problems with your fire system. In Case of Carbon Monoxide Alarm 1. In the event of a carbon monoxide emergency, the CO detector will automatically send signals to your Control/Communicator, triggering a loud interrupted sound from the keypad. An interrupted sound will also be produced by optional exterior sounders. EVACUATE ALL OCCUPANTS FROM THE PREMISES IMMEDIATELY. Notify your Central Station/Security Company immediately and wait for further instructions. Silencing and Clearing a Carbon Monoxide Alarm 1. Once all is clear, silence, acknowledge, and clear the alarm by: a. For Residential Systems: Press "Touch here to Silence" on the display to silence the alarm. For Commercial Systems: Enter your code. This will silence and acknowledge the alarm and disarm the system (if armed). b. Press the CLEAR button followed by your code. This will acknowledge the alarm and disarm the system (if armed). c. Press the DISPLAY FAULTS button on the Arming screen. The faulted carbon monoxide zone will be displayed. d. Press the CLEAR button and then enter your code. This will clear the Carbon Monoxide Alarm from the system. 2. If the keypad does not indicate a READY condition after the second sequence, press the DISPLAY FAULTS key on the Arming screen to display the zone(s) that are faulted. Be sure to check that the carbon monoxide detectors are not responding to gas producing objects in their vicinity. In this case, eliminate the source of the leak. 3. If this does not remedy the problem, there may still be gas in the detector. 4. When the problem has been corrected, clear the display by entering the DISPLAY FAULTS button on the Arming screen, selecting the 27