Honeywell RCWL8000A1002 User Guide - Page 10

Expanding your system There are many ways to expand your entry system: you can connect your system to a television set or add more cameras, for example. TV connection You can connect the receiver to a TV set via the accessory SCART cable. The TV set must be equipped with a SCART input. When the door camera is activated, the receiver chimes and the TV switches automatically to display the caller on the TV. Note: the automatic picture display is activated using the TV SCART trigger mode. Some SCART sockets and some TV sets will not work in this mode and you may need to change channels manually. Refer to the TV set instructions for advice. Adding a door chime The door camera can trigger one or more Friedland Evo or Décor chimes in addition to the video receiver. Additional chimes may be useful in large or noisy premises. Note: if you are using an existing chime, you will need to clear it before it can be programmed to respond to the video camera. To do this, press and hold in the two chime selection buttons 'A and B' on the chime for around six seconds until it starts playing its available tunes. The chime is now cleared. To program the chime, make sure it is located within 8m (25ft) of the door camera and press and hold the camera call button until the chime sounds. The chime in now programmed and ready for use. Use the tune button on the chime to change the tune if required. Refer to the chime instructions for more detailed information. Note that a chime can be programmed with a total of two door cameras or pushes. Once programmed, the additional chime will respond to the door camera call button, but not the tamper switch. Note: If the wireless door push supplied with a chime is not required, it can be used as an additional door push to activate the video entry receiver - see below. Additional door cameras The receiver will respond to up to four door cameras. Each camera must be set on a different video channel (1-4), and be programmed into the receiver. Refer to the instructions provided with the additional unit, or see 'To reprogram or reset the receiver', in this section. Adding CCTV units Compatible Friedland products (available from January 2006) will allow you to continuously view the outside or inside of your premises. Programming is simple, as with an additional door camera. Refer to the instructions supplied with the add-on product for full details. To reprogram or reset the receiver A. To add another door camera, CCTV unit or bell push: Press and hold the ' ' button for more than five seconds, the unit will beep three times and enter programming mode for approximately two minutes. During the two minute programming time, press the call button or button on the new unit to program it in. The unit must be within 10-20m of the receiver to ensure reliable programming. B. To clear all programmed data, e.g. when replacing a door camera: Press and hold both the ' ' and ' ' buttons in for five seconds to clear the programmed data and enter programming mode. The available chime sounds play. Follow the programming sequence under Receiver Setup. Adding a door push The receiver will respond to a Friedland Evo or Décor door push. To program a door push into the receiver: 1. Press and hold the ' ' button for approximately five seconds until the receiver beeps three times 2. Press the door push button until the receiver sounds. Note: The video receiver does not respond to a door push while the video screen is active. G-9