Honeywell RCWL8000A1002 User Guide - Page 9
Chime tune selection, Night operation, Low camera battery indication, Tamper alert tone, MIC volume
UPC - 085267333979
View all Honeywell RCWL8000A1002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
English Chime tune selection The receiver chime tune can be changed by pressing the ' ' button. Chime tune options are as follows: ■ Two note bell (Default tune for door camera) ■ Saxophone (Default tune for second door camera or bell push) ■ Single note bell ■ Knock. The ' ' button changes the chime tune for a second door camera or a door push Night operation In good daylight conditions, the receiver displays a colour picture. In low lighting or at night the display automatically switches to black and white. Infrared LEDs illuminate the caller, so they can be viewed on the receiver even when surrounded by complete darkness. DOOR CAMERA Motion sensor The PIR ('Passive InfraRed') sensor activates the door camera automatically. The receiver produces a 'ping' sound and displays the door camera image for approximately 30 seconds. If the motion sensor is not required, then it can be disabled. To switch the motion sensor off, press and hold the call button on the camera for more than ten seconds. The confidence indicator blinks rapidly to confirm that the motion sensor is disabled. To switch the motion sensor back on, press and hold the call button for more than ten seconds, the confidence indicator remains on for two seconds to confirm. Note: Power loss to the camera or a change of batteries will reset the sensor back on. Low camera battery indication When the batteries in the door camera are running low, the receiver indicates this with a double beep warning tone that follows the chime when a visitor presses the call button. Replace the batteries in the door camera within one week of a low battery alert. Tamper alert tone If someone attempts to remove the door camera by unscrewing the cover screws, the tamper alert tone is triggered, beeping for 30 seconds. Check outside immediately. Press any button on the front of the receiver to stop the alert tone. The alert tone is unaffected by the chime volume switch. Note: The alert is also triggered when you undo the cover to replace batteries in the door camera. MIC volume [For future use] The topmost control along the side (see diagram) will control the volume produced from a microphone. Adjust for optimum listening level. Scan button [For future use] When used in a multi-camera system, this button scans through available pictures. Privacy Remember that this product uses the public airwaves, and that the 30-second duration video signal from the door camera(s) can be picked up by nearby 2.4GHz video receiving devices. G-8