Honeywell TD43996615 User Manual - Page 18

Searching for the signals from the remote sensor Corresponding remote sensor signal received successfully No signals received for over 15 minutes ALL REMOTE SENSORS SIGNAL ACTIVATION The main unit can be manually activated to search for the signals from remote sensors by pressing and holding DOWN button. WIND WINDOW The left section of the Wind Window can be programmed to display either a temperature at the place of anemometer or the temperature adjusted to the wind chill factor. The right section of the Wind Window indicates the average wind speed for the past 10 minutes, as well as gust, high wind speed and gust alarm information. It can also show records of the maximum wind speed and wind gust collected during the day. The wind speed and gust can be programmed to alert you if the wind speed or gust exceeds a pre-set limit. The wind speed can be displayed in km/h, mph, m/s or knots. ACCESSING Press UP or DOWN until the WIND icon on the display starts flashing. OPERATING In the Wind Window press the SET button to recall: • Wind chill temperature with wind speed 35 • Temperature at anemometer with wind speed PROGRAMMING UNITS In the Wind Window, press and hold SET to set the wind speed units in km/h, mph, m/s or knots. VIEWING STATISTICS In the Wind Window, press the MEM button to recall: • Current wind speed, a daily maximum wind speed with "DAILY MAX" displayed, a gust speed with a "GUST" displayed and a daily maximum gust speed with a "GUST DAILY MAX" displayed. RESETTING STATISTICS MEMORY In the Wind Window, press and hold MEM to reset all wind statistics. ACTIVATING OR DEACTIVATING ALARMS In the Wind Window press ALARM to recall • Current wind speed • Wind speed alarm with the "ALARM HI" displayed • Wind gust alarm with the "GUST ALARM HI" displayed • Daily maximum wind speed with "DAILY MAX" displayed If the specific alarm is disabled, "OFF" will be displayed; otherwise the alarm value will be shown. When the wind alarm is displayed, press the UP or DOWN to activate or deactivate it. PROGRAMMING HIGH WIND ALARM • In the Wind Window, press ALARM to select the desired alarm (wind 35 36