Honeywell TD43996615 User Manual - Page 19
Maintanance, Troubleshooting, Precautions
UPC - 961613054432
View all Honeywell TD43996615 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
speed or wind gust speed) • Press and hold ALARM button until speed digit will flash. • Set the alarm using the UP or DOWN. Press and hold either button for fast digits advance. • Press ALARM to confirm your selection and return to the high wind alarm selection screen. MAINTANANCE CHANGING BATTERIES The battery status of each weather sensor is checked every hour. If the low battery indicator lights up, replace the batteries in the corresponding unit. CHANGING BATTERIES IN THE MAIN UNIT • Remove the battery compartment door from the back and replace batteries. Do not mix old and new batteries • Replace the battery compartment door CHANGING BATTERIES IN REMOTE SENSORS • Replace the batteries following the setup instructions for the corresponding sensor • When the batteries are properly installed, the remote weather sensor will resume sending signals to the main unit • To enforce an immediate remote signals search, press and hold DOWN on the main unit CLEANING The main unit and outer casings of the remote weather sensors can be cleaned with a damp cloth. Small parts can be cleaned with a cotton tip or pipe-cleaner. 37 Never use any abrasive cleaning agents and solvents. Do not immerse any units with electronic parts in water or under running water. WIND METER Check if the wind cups can spin freely and are free from dirt, debris and spider webs. TROUBLESHOOTING Check here before contacting customer service. Issue Main unit Main unit Remote sensor Symptom US Atomic Time signal is not received The weather readings weather station are different from the TV, radio or official weather reports Cannot locate remote sensor Solution Place unit by the window and keep it there overnight The weather data may vary considerably due to different environmental conditions and placement. Check the placement tips included in this manual to site your weather sensors in the best possible way. Check batteries Check location Cannot change the channel Cannot change the C° to F° and back Data does not match data on the main unit Press and hold DOWN ( ▼) button on the main unit to search for the signal form the remote sensor Press "RESET" after setting the channel Press "RESET" after setting C/F Initiate manual sensor search (Press and hold DOWN ( ▼) button on the main unit) PRECAUTIONS This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions: • Do not immerse the units in water. 37 38