Hotpoint HDA3600RBB Installation Instructions - Page 12
Step 15: Connect Drain Line
UPC - 084691207719
View all Hotpoint HDA3600RBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Dishwasher Installation STEP 15: CONNECT DRAIN LINE The molded end of the drain hose will fit 5/8" through 1" diameter inlet ports on the air gap, waste tee or disposer. • Determine the size of the inlet port • Cut the drain hose connector on the marked line, if required, to fit the inlet port. Method 1 - Air gap with waste tee or disposer Figure V Waste Tee Installation Disposer Installation Figure X Method725-6"DHiigah6d0rain 756Dia61 loop" with waste tee or disposer Fasten the drain hose to the underside of the countertop with a hanger. • If a longer drain hose is required, and you did not purchase the GPF10S drain hose, add up to 42" length, for a total of 120" (10 feet), to the factoryinstalled hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps. Figure W IMPORTANT - Total drain hose length must not exceed 10 feet for proper drain operation. Waste Tee Installation Figure Y Disposer Installation IMPORTANT - When connecting the drain line to a disposer, check to be sure that the drain plug has been removed. Dishwasher will not drain if plug is left in place. • Connect drain line to air gap, waste tee, or disposer using the previously determined method. Secure the hose with a screw-type clamp. Remove Drain Plug Tip: Avoid unnecessary service call charges fMoarkae"snuoredaraniyn"exc1coem8ssp7lda1rianAitn.rhto1se has been pulled through the cabinet opening. This will prevent excess hose in the dishwasher cavity from becoming kinked or crushed by the dishwasher. Make sure the disposer plug has been removed if the drain hose is connected to a disposer. 12