Hotpoint HDA3600RBB Installation Instructions - Page 15

Dishwasher Installation STEP 20: replace access panel and toekick In this step you will need the panels and the two screws set aside in Step 4. There are two types of screws used. The 8-32 x 1/4" screws are used at the top of the access panel and should still be in place. The 10-16 x 3/8" screws are used at the bottom of the access panel and secure both the access panel and toekick. STEP 21: LITERATURE ■ Leave the Owners' Manual, Installation Instructions, samples and/or coupons with consumer. IMPORTANT - Screws are not interchangeable. To prevent damage to your dishwasher, use the proper screw in the proper location. Do not mix screw types or lengths. • Place the toekick against the legs of the dishwasher. • Remove the two 8-32 x 1/4" machine-thread screws. • Align the access panel to the dishwasher. • Select the two 8-32 x 1/4" machine-thread screws just removed and insert them through the top holes in the access panel and into the dishwasher frame. • Tighten these screws. • Align the toekick and make sure the bottom edge is against the floor. • Insert and tighten the two 10-16 x 3/8" sheet metal thread screws, making sure the bottom edge of the toekick stays in contact with the floor. Figure AA Tip: Prevent tub damage and reduce sound from under the dishwasher. Use the machine-thread screws in the top holes and the sheet metal-thread screws in the bottom holes. Make sure the toekick is against the floor. 15