Hotpoint HDA3600RCC Installation Instructions - Page 10

Dishwasher Installation STEP 11: SLIDE DISHWASHER INTO CABINET IM PORTANT - Do not push againstthe front panel with knees. Damage will occur. • Grasp the sides of the front panel and slide the dishwasher into the opening a few inches at a time. Pull the drain hose and power cord, if equipped, through the holes in the adjacent cabinet while sliding the dishwasher into position. STEP 12: POSITION AND LEVEL DISHWASHER IM PORTANT- Dishwasher must be level for proper dish rack operation, wash performance and door operation. The dishwasher must be leveled left to right and front to back. This ensures that the dish racks will not roll in or out on their own, circulation water will flow to the pump inlet, and the door will close without hitting the side of the tub. , Remove the lower dish rack and place a level on the door and lower rack track as shown in Figure R. Figure Q Do not push against front door panel with knee. Damage to the door panel will occur. Check Level Front to , Check the tub insulation blanket, if equipped, to be sure it is smoothly wrapped around the tub. It should not be "bunched up" and it must not interfere with the door springs. If the insulation is "bunched up" or interfering with the springs, straighten and re-center the blanket prior to sliding the dishwasher into its final position. • Make sure the drain hose is not kinked under or behind the dishwasher. • Make certain the house wiring, drain line and water line do not interfere with components under the dishwasher. , The dishwasher tub flange should be approximately 3/4" behind the face of the adjacent cabinet. Refer to Figure R. Tip: Avoid unnecessar£1 service charges for panel damage. Do not press on the center of panel with hands or knees when sliding dishwasher into position. 10 Figure R Side to Side • Adjust the level of the dishwasher bU individuallLI turning the four legs on the bottom of the dishwasher as illustrated in Figure S. °. \'L _ Turn Lec / to Adjust _ FigureS • The dishwasher is properly leveled when the level indicator is centered left to right and front to back. The dishwasher door should close without hitting the sides of the tub. • Replace the lower rack. Tip: Avoid unnecessarg service charges for poor wash performance and rack operation. Pull the dish racks half wa U out. The U should remain stationary. Open and close the door. The door should fit in the tub opening without hitting the side of the tub. If the racks roll on their own, or the door hits the side of the tub, relevel the dishwasher.