Hotpoint HDA3600RCC Installation Instructions - Page 3

installation Preparation - Enclosure PREPARE DISHWASHER ENCLOSURE To reduce the risk of shock, fire, or injurg to persons, the installer must ensure that the dishwasher is completelg enclosed at the time of installation. , The dishwasher must be installed no more than 10 feet from sink for proper drainage. , The dishwasher must be fullg enclosed on the top, sides and back. , The dishwasher must not support any part of the enclosu re. Para redudr el riesgo de choque, incendio o lesi6n a personas, el instalador se debe cerdorar de que la lavadora est_ completamente cerrada en el momento de la instalad6n. , The rough cabinet opening must have a minimum width and depth of 24" and height of 34-1/2" _+1/4" from the floor to the underside of the countertop. , The back wall should be free of pipes or wires. , Adjacent cabinets should be square and plumb to ensure a good fit. Refer to Figure A. , For a corner installation, allow 2" minimum clearance between the dishwasher and the adjacent wall. , Provide at least 27" in front of the dishwasher to allow the dishwasher door to open fullg. Refer to Figure B. I 1' Countertop [_ DishwosheI i Clearances: In a corner installation, provide at least 2" clearance between the dishwasher and the adjacent Provide at least 27" of clearance cinabfrionnett, owf athlle odrisohthwearshaepr.pliance. 27" Minimum Figure 8 34-1/2"_+ 1/4" Underside of Countertop to Floor This Wall Area must be Free of Pipes or wires Squore and Plumb Floor MUST be Even with Room Floor Figure A Plumbing and Electric Service Must Enter Shaded Area • Make sure the floor is level inside the opening and even with the finished floor of the kitchen. This will facilitate removal of the dishwasher at a later date for service, if needed.