Hotpoint HDA3600RCC Installation Instructions - Page 4

Installation Preparation - Drain PREPARE DRAIN PLUMBING Drain Requirements • Follow local codes and ordinances. • Drain hose must not exceed 10 feet in length. , A high drain loop or air gap is required. See below. Drain Method The type of drain installation depends on the following: • Do local codes or ordinances require an air gap? • Is waste tee less than 18" above the floor? If the answer to either question is YES, an air gap (Method 1) must be used. If both answers are NO, either an air gap or a high drain loop (Method 2) may be used. METHOD 1 - Air Gap with Waste Tee or Disposer __ ra Waste Tee Installation Figure C Disposer Installation METHOD 2- High Drain Loop with Waste Tee or Disposer Provide a method to attach the drain hose to the underside of countertop. Attachment will be made in a later step. Special consideration for a dishwasher installed on a pedestal If the dishwasher is installed on an elevated platform, a high drain loop of at least 32" above the platform must be provided in addition to the air gap requirement determined above. This is necessary for proper drain performance. Waste Tee Installation Figure D Disposer Installation Install waste tee or disposer and the air gap according to the manufacturer's instructions. CAUTION An air gap MUST BE USED if the drain hose is connected to waste tee or disposer lower than 18" above the floor level. Failure to provide the proper drain connection height with an air gap or 32" minimum, high drain loop will result in improper draining of the dishwasher, which mag cause damage. Cabinet Preparation Drill a 1-1/2" diameter hole in the cabinet wall within the shaded area shown in Figure A for the drain hose. Make sure there are no sharp edges. The drain hose will be passed through this hole and connected to the drain in a later step. PRECAUCION SE DEBE USAR un espado de aire si la manguera de drenaje se conecta a la T de desechos o al triturador menos de 18" por endma del nivel del piso. No disponer la altura correcta de la conexi6n del drenaje con un espacio de aire o 32" de minima, una curva alta de drenaje resultar_ en un drenaje incorrecto de la lavadora, Io que pude causar da_os. IMPORTANT- When connecting the drain line to a disposer, check to be sure that drain plug has been removed. Dishwasher will not drain if plug is left in place. f===y 4 L:f Remove Drain Plug