Hotpoint HDA3600RCC Installation Instructions - Page 13

Dishwasher Installation STEP 16: CONNECT POWER SUPPLY If a power cord with plug is already installed, proceed to Step 17. STEP 17: INSTALL JUNCTION BOX COVER If junction Step 18. box cover is already installed, skip to If the dishwasher came with a factory-installed power cord and you want to convert it to a permanent connection, refer to the instructions on page 16. If house wiring is not 2-wire with a ground wire, a ground must be provided by the installer. When house wiring is aluminum, be sure to use U.L. listed anti-oxidant compound and aluminum-to-copper connectors. Si el cableado de la casa no es de 2 cables con un cable de conexi6n a tierra, el instalador debe suministrar una conexi6n a tierra. Cuando el cableado de la casa es en aluminio, cerci6rese de usar un compuesto anti-oxidante aprobado par U.L y un compuesto de aluminio a cobre. • Secure house wiring to the back of the junction box bracket with o strain relief. . Locate the three dishwasher wires (white, black and green) with stripped ends. Insert dishwasher wires through the small hole in the junction box bracket. Use UL-listed wire nuts of appropriate size to connect incoming ground to green, white to white and black to black. Note: Check that harness leads ore threaded through small hole in bracket Junction Ground Box Bracket White \ Figure Z In this step you will need the junction box cover and the #10 hex-head screw from the screw kit set aside in Step 1. , Install the junction box cover using the #10 hexhead screw. Check to be sure that wires ore not pinched under the cover. STEP 18: PRETEST CHECKLIST [] Verify that power is turned off at the source. [] Open the dishwasher door and remove all foam and cardboard packaging. [] Read the Owner's Manual to familiarize yourself with the operation of the dishwasher. [] Check to be sure that the wiring is secure under the dishwasher and not pinched or in contact with door springs or other dishwasher components. [] Check that the door spring does not contact the water line, fill hose, or adjacent cabinets. See Steps 13 and 14. [] Pull lower rack about halfway out. Check to be sure it does not roll back into dishwasher or further out. If it does, relevel the dishwasher. See Step 12. [] Check to be sure control panel does not touch adjacent cabinets. If it does, reposition the dishwasher. See Step 13. [] Turn on the hot water faucet at the sink to verify that the water temperature is at least 120°F and not more than 150°R Adjust water heater if necessary. [] Add two quarts of water to the bottom of the dishwasher to lubricate the pump seal. [] Turn on water supply. [] Check for water leaks. Tighten connections if necessary. See Step 14. [] Remove the protective film, if present, from the control panel, access panel and door panel. 13