Hotpoint HDA3600RCC Installation Instructions - Page 6

Installation Preparation - Hot Water Supply PREPARE HOT WATER SUPPLY Hot Water Line ,, The line may enter from either side, rear or floor within the shaded area shown in Figure F. ,,The line may pass through the same hole as the electrical cable and drain hose, or cut an additional 1-1/2" diameter hole to accommodate the water line. If a power cord with plug is used, the water line must not pass through the power cord hole. CAUTION The hot water supply line pressure must be at least 20 PSI. Lower pressures could cause the water valve to leak and cause water damage. PRECAUCI6N La Jinea de presi6n del suministro de ague caliente debe ser al menos 20 PSL Presiones inferiores podrian causer que la v6lvula del ague gotee y causer da6os por ague. \ \ Figure F Water Line Connection • Turn off the water supplg. ,, Install a hand shut-off valve in an accessible location, such as under the sink. (Optional, but stronglg recommended and mag be required bg local codes.) ,, The water connection is on the left side of the dishwasher. Install the hot water inlet line, using 3/8" or larger copper tubing. Route the line as shown in Figure F and extend forward at least 19" from rear wall. ,, Adjust the water heater to deliver water between 120% and 150°R • Flush water line to clean out debris. Use a bucket to catch water and debris. • The hot water supplg line pressure must be between 20 and 120 PSI.