Hunter 20578 Owner's Manual - Page 10

2 • Installing the Ceiling Mounting Plate (continued) 2.5 Note: The isolators must be flush against the ceiling. A loose ceiling mounting plate will result in improper operation of the Auto Balance™system. 2.6 2 2 68 65 Align the slotted holes in the ceiling mounting plate (2) with the pilot holes you drilled in the wood support structure. For proper alignment, use slotted holes directly across from each other. Place a flat washer (68) on each of the two 3" wood screws (65). Insert the screws into the slotted holes in the ceiling mounting plate (2) into the pilot holes you drilled. Tighten the screws (65) into the 9/64" pilot holes; do not use lubricants on the screws. Do not over tighten. Tabs 2.7 Toward Ceiling Peak 2.8 2 For Angled Ceilings: Be sure to orient the ceiling mounting plate (2) so that the two tabs are pointing toward the ceiling peak. Unbundle the wires from the fan. Note: Your Hunter fan comes with an optional pipe/ball assembly extension pipe. If you are hanging the fan on a ceiling higher than 10 feet tall and you would like to use the enclosed optional pipe/ball assembly, follow Steps 3.5 - 3.9. 6 42798-01 • 12/28/09 • Hunter Fan Company