Hunter 20578 Owner's Manual - Page 25

11 • Operation & Maintenance Operation Cleaning and Maintenance The fan pull chain controls power to the fan. • The pull chain has four settings in sequence: High, Medium, Low, and Off. • Pull the chain slowly to change settings. • Release slowly to prevent the chain from recoiling into the blades. • The chain uses a breakaway connector that separates if the chain is jerked. If this happens, simply reinsert the chain into the connector. The light pull chain controls the power to the light fixture. • The chain has two settings: ON and OFF. Caring for finishes: For cleaning finishes, use a soft brush or lint-free cloth to prevent scratching. A vacuum cleaner brush nozzle can remove heavier dust. Remove surface smudges or accumulated dirt and dust using a mild detergent and a slightly dampened cloth. You may use an artistic agent, but never abrasive cleaning agents as they will damage the finish. Caring for blades: Note: Be careful to not bend the blades when cleaning. Clean wood finish blades with a furniture polishing cloth. Occasionally, apply a light coat of furniture polish for added protection and beauty. Clean painted and high-gloss blades in the same manner as the fan finish. Troubleshooting Problem: Nothing happens; fan does not move. 1. Turn power on, replace fuse, or reset breaker. 2. Loosen canopy, check all connections according to the wiring the fan section. 3. Check the plug connection in the switch housing. 4. Push motor reversing switch firmly left or right to ensure that the switch is engaged. 5. Pull the pull chain to ensure it is on. 6. Remove the shipping bumpers. Problem: Noisy operation 1. Tighten the blade assembly screws and blade iron armature screws until snug. 2. Check to see if the blade is cracked. If so, replace all the blades. Problem: Excessive wobbling 1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan. 2. Tighten all blade iron screws. 3. Turn power off, support fan very carefully, and check that the hanger ball is properly seated. Problem: Lights turn off when installed or dim when turned on 1. Check to make sure the wattage and type of light bulbs installed match the specifications on the light socket. Problem: Lights shut off suddenly 1. Turn the power to the fan off at the wall switch. Wait 30 seconds, then resume power to the fan.If you have tried these troubleshooting solutions and still have trouble, visit our Web site at: http://www.hunterfan.com. Hunter Fan Company 7130 Goodlett Farms Parkway #400 Memphis, Tennessee 38016 21 42798-01 • 12/28/09 • Hunter Fan Company