Husqvarna AUTOMOWER 550 Owner Manual - Page 14
min 30 cm / 12
View all Husqvarna AUTOMOWER 550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
station to the ground. See Laying and connecting the guide wire on page 20. min 30 cm / 12" WARNING: No parts of the power supply must under any circumstances be changed or tampered with. The low voltage cable must not be shortened or extended. CAUTION: Place the low voltage cable so that the blades on the blade disc can never come in contact with it. CAUTION: Use the plug to disconnect the charging station, for instance before cleaning or repairing the loop wire. 3.3.3 Installing and connecting the charging station 1. Position the charging station in a suitable spot. See Best charging station location on page 12. 2. Tilt the protective cover on the charging station forward and connect the low voltage cable to the charging station. CAUTION: It is not permitted to make new holes in the charging station's plate. Only the existing holes may be used to secure it to the ground. CAUTION: Do not tread or walk on the charging station's plate. 3. Connect the power supply's power cable to a 100-240V wall socket. If the power supply is connected to an electrical socket outdoors, this must be approved for outdoor use. See Connecting the power supply on page 13. 4. Attach the charging station to the ground using the supplied screws. Ensure the screws are screwed all the way down in the countersink. Note: The guide wire must be laid and connected to the charging station before securing the charging 3.4 Charging the battery When the charging station is connected, it is possible to charge the robotic lawnmower. Set the main switch to position 1. Place the robotic lawnmower in the charging station while the boundary and guide wires are being laid. If the battery is flat, it takes about 80 to 100 minutes to fully charge it. WARNING: Only charge the robotic lawnmower using a charging station which is intended for it. Incorrect use may result in electric shock, overheating or leakage of corrosive liquid from the battery. In the event of leakage of electrolyte flush with water and seek medical help if it comes in contact with the eyes etc. Note: The robotic lawnmower cannot be used before the installation is complete. 3.5 Boundary wire The boundary wire can be installed in the following ways: 14 - Installation 362 - 002 - 06.02.2018