Husqvarna Z246 Owners Manual - Page 18

OPERATION Before Starting 1. Read the sections on Safety and Controls before starting the machine. 2. Perform the daily maintenance before starting (see Maintenance Schedule in the Maintenance section). 3. Check that there is sufficient fuel in the fuel tank. 4. Adjust the seat to the desired position. The following conditions must be fulfilled before the engine can be started: • The blade switch must be pressed down into the disengaged position. • Both steering / park brake controls must be in the locked (outer) position. 4. Move the steering / park brake controls out to the locked position. WARNING! Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects or other reproductive system damage. The engine exhaust contains carbon monoxide, which is a odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces. Starting the Engine 1. Sit on the seat. 2. Raise the mower deck to the highest position. 5. Move the throttle lever to the full throttle position. NOTE: There is a detent at the full throttle position to aid in setting the control. 3. Disengage the mower blades by pressing the blade switch downwards. If the temperature is below 32OF, move the throttle lever up to the cold weather (snowflake) starting position. When the engine has started, move the throttle lever back to full throttle detent and allow the engine to warm up for a short period before operating the unit. Failure to move the throttle from the cold weather starting position will result in poor engine performance, smoke and spark plug fouling. IMPORTANT INFORMATION Under normal starting conditions, use a press and release method for the ignition start/stop switch. Do not press and hold. 18