Husqvarna Z246 Owners Manual - Page 23
Moving Machine By Hand, WARNING
View all Husqvarna Z246 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
OPERATION Moving Machine By Hand When pushing or pulling the mower, engage the EZT bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard. 1. Raise the deck into the highest cutting position. 2. Move the steering / park brake controls inwards to the neutral position. 3. Pull the EZT bypass linkages up and out of the keyhole slots. Release the levers with the head outside the frame and held in the bypass position. 4. To reengage the EZT's to drive, reverse the above procedure. WARNING! Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levers are handled. WARNING! Make no adjustments without: • the engine stopped, • the ignition switch turned off, • the park brake activated WARNING! Use extreme caution when loading the machine into a truck or trailer using ramps. There is the possibility of serious injury or death if the machine falls off the ramps. Load the machine into truck or trailer by driving slowly up the ramps. DO NOT LIFT! The machine is not intended to be lifted by hand. 23