IBM 865811Y User Guide - Page 31

Table, Novell, NetWare, IntraNetWare, driver, messages, Ethernet, controller, continued

Get IBM 865811Y - Netfinity 5100 - 8658 PDF manuals and user guides
UPC - 087944531869
View all IBM 865811Y manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Table 2. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller (continued) PCNTNW-NW-058 The adapter did not respond to the initialization command. Explanation: The interrupt request (IRQ) setting might not be valid or the EEPROM information might be incorrect. Action: Make sure the IRQ settings are correct in the Configuration/Setup Utility program. for information on setting the interrupt requests. PCNTNW-NW-066 The cable might be disconnected from the adapter. Explanation: The cable might be disconnected from the server Ethernet port. Action: Verify that a cable is connected to the Ethernet port. PCNTNW-NW-071 The matching virtual adapter could not be found. Explanation: You tried to load another instance of the driver with a different I/O address. This new adapter could not be found. Action: Verify that you installed an IBM Netfinity 10/100 Fault Tolerant Adapter and make sure that the adapter is seated correctly. PCNTNW-NW-072 A resource tag is unavailable. Explanation: The driver tried to allocate some resources that were not available. Action: Add more memory, or free some memory resources in the server. Then, restart the server. PCNTNW-NW-073 Unable to allocate memory Explanation: The driver failed to allocate the memory needed for normal operation. Action: Add more memory, or free some memory resources in the server. Then, restart the server. PCNTNW-NW-074 The hardware interrupt cannot be set. Explanation: An attempt was made to initialize a given hardware interrupt. The attempt was not successful. Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go to "Starting the diagnostic programs" on page 16 to run the diagnostic programs. If you have an Ethernet adapter installed, make sure that the adapter does not share an IRQ with any other device. PCNTNW-NW-075 The Multiple Link Interface Driver (MLID) cannot be registered with the Link Support Layer (LSL). Explanation: An error occurred while the driver was trying to register with the LSL. Action: Check the version of the NetWare or IntraNetWare Operating System. Make sure that this driver is correct for the version of NetWare or IntraNetWare that you are using. Restart the server. PCNTNW-NW-079 The Multiple Link Interface Driver (MLID) did not initialize MSMTx Free Count. Explanation: The MSMTx Free Count is not initialized correctly. Action: Restart the server. PCNTNW-NW-086 The driver parameter block is too small. Explanation: The driver parameter block is too small. Action: Restart the server. Diagnostics 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
Table
2.
Novell
NetWare
or
IntraNetWare
ODI
driver
messages
for
the
Ethernet
controller
(continued)
PCNTNW-NW-058
The
adapter
did
not
respond
to
the
initialization
command.
Explanation:
The
interrupt
request
(IRQ)
setting
might
not
be
valid
or
the
EEPROM
information
might
be
incorrect.
Action:
Make
sure
the
IRQ
settings
are
correct
in
the
Configuration/Setup
Utility
program.
for
information
on
setting
the
interrupt
requests.
PCNTNW-NW-066
The
cable
might
be
disconnected
from
the
adapter.
Explanation:
The
cable
might
be
disconnected
from
the
server
Ethernet
port.
Action:
Verify
that
a
cable
is
connected
to
the
Ethernet
port.
PCNTNW-NW-071
The
matching
virtual
adapter
could
not
be
found.
Explanation:
You
tried
to
load
another
instance
of
the
driver
with
a
different
I/O
address.
This
new
adapter
could
not
be
found.
Action:
Verify
that
you
installed
an
IBM
Netfinity
10/100
Fault
Tolerant
Adapter
and
make
sure
that
the
adapter
is
seated
correctly.
PCNTNW-NW-072
A
resource
tag
is
unavailable
.
Explanation:
The
driver
tried
to
allocate
some
resources
that
were
not
available.
Action:
Add
more
memory,
or
free
some
memory
resources
in
the
server.
Then,
restart
the
server.
PCNTNW-NW-073
Unable
to
allocate
memory
Explanation:
The
driver
failed
to
allocate
the
memory
needed
for
normal
operation.
Action:
Add
more
memory,
or
free
some
memory
resources
in
the
server.
Then,
restart
the
server.
PCNTNW-NW-074
The
hardware
interrupt
cannot
be
set.
Explanation:
An
attempt
was
made
to
initialize
a
given
hardware
interrupt.
The
attempt
was
not
successful.
Action:
Verify
that
the
Ethernet
controller
is
enabled.
If
the
Ethernet
controller
is
enabled,
go
to
“Starting
the
diagnostic
programs”
on
page
16
to
run
the
diagnostic
programs.
If
you
have
an
Ethernet
adapter
installed,
make
sure
that
the
adapter
does
not
share
an
IRQ
with
any
other
device.
PCNTNW-NW-075
The
Multiple
Link
Interface
Driver
(MLID)
cannot
be
registered
with
the
Link
Support
Layer
(LSL).
Explanation:
An
error
occurred
while
the
driver
was
trying
to
register
with
the
LSL.
Action:
Check
the
version
of
the
NetWare
or
IntraNetWare
Operating
System.
Make
sure
that
this
driver
is
correct
for
the
version
of
NetWare
or
IntraNetWare
that
you
are
using.
Restart
the
server.
PCNTNW-NW-079
The
Multiple
Link
Interface
Driver
(MLID)
did
not
initialize
MSMTx
Free
Count.
Explanation:
The
MSMTx
Free
Count
is
not
initialized
correctly.
Action:
Restart
the
server.
PCNTNW-NW-086
The
driver
parameter
block
is
too
small.
Explanation:
The
driver
parameter
block
is
too
small.
Action:
Restart
the
server.
Diagnostics
21