IBM 865811Y User Guide - Page 49
Format, Attention
UPC - 087944531869
View all IBM 865811Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Note: If you press Ctrl+A before the selected drives are ready, a screen similar to the following might appear. Restart the server and watch the SCSISelect messages as each drive spins up. After the drive that you want to view or format spins up, press Ctrl+A. v Format Disk Attention: The Low-Level Format program erases all data and programs. Select this choice to perform a low-level format on a hard disk drive. Depending on the hard disk drive capacity, the Low-Level Format program could take up to two hours. Use the Low-Level Format program: - When you are installing software that requires a low-level format - When you get recurring messages from the diagnostic tests directing you to run the Low-Level Format program on the hard disk drive - As a last resort before replacing a failing hard disk drive Note: If your server has a PCI RAID adapter installed, refer to the RAID adapter documentation for instructions for performing low-level formats on hard disk drives attached to the adapter. To start the Low-Level Format program: 1. If the hard disk is working, make a backup copy of all the files and programs on the hard disk drive. (See your operating system information for instructions.) 2. Select Format Disk; then, follow the instructions on the screen. Note: Hard disks normally contain more tracks than their stated capacity (to allow for defective tracks). A message appears on the screen if the defect limit is reached. If this happens, have the system serviced. Configuring the server 39