IBM 865811Y User Guide - Page 85
Serial, ports
UPC - 087944531869
View all IBM 865811Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Table 11. Parallel-port connector pin-number assignments (continued) 9 I/O Data 7 Data 7 10 I -ACK -ACK 11 I BUSY -WAIT 12 I PE (paper end) PE (paper end) 13 I SLCT (select) SLCT (select) 14 O -AUTO FD (feed) -AUTO FD 15 I -ERROR -ERROR 16 O -INIT -INIT 17 O -SLCT IN -SLCT IN 18 - Ground Ground 19 - Ground Ground 20 - Ground Ground 21 - Ground Ground 22 - Ground Ground 23 - Ground Ground 24 - Ground Ground 25 - Ground Ground Serial ports Your server has two standard serial ports: Serial port A and Serial port B. The operating system can use and share both serial ports; however, the integrated Netfinity Advanced System Management Processor can use and share only Serial port A. Some application programs require specific ports, and some modems function properly only at certain communication port addresses. You might need to use the Configuration/Setup Utility program to change communication port address assignments to prevent or resolve address conflicts. Viewing or changing the serial-port assignments To view or change the serial-port assignments: 1. Restart the server and watch the monitor screen. 2. When the message Press F1 for Configuration/Setup appears, press F1. 3. From the main menu, select Devices and I/O Ports; then, press Enter. Note: The Devices and I/O Ports choice appears only on the full configuration menu. If you set two levels of passwords, you must enter the administrator password to access the full configuration menu. 4. Select the serial port; then, use the arrow keys to advance through the settings available. 5. Select Save Settings; then, select Exit Setup to exit from the Configuration/Setup Utility main menu. Serial-port connectors The following table shows the pin-number assignments for the 9-pin, male D-shell serial-port connectors on the rear of your server. These pin-number assignments Installing options 75