IBM 86594RY Hardware Maintenance Manual - Page 112
Preparing the rack enclosure, rails, and attach the template to the rear
UPC - 087944479673
View all IBM 86594RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Preparing the rack enclosure: In this section, you will use the following parts: Two slide bracket assemblies Two slide rails (fitted to system unit) One cable-management arm Ten long screws (M6 by 16 mm) Ten cage nuts Installation template Attention To ensure cabinet stability, plan the installation of servers in the rack enclosure starting from the bottom. Note This procedure requires two people. To attach the mounting hardware to the rack enclosure: 1. Mark the positions of the slide brackets on the mounting rails on the rack enclosure. a. Position the template on the front mounting rail on the rack enclosure, aligning the holes. Secure the template in place with tape. b. Mark the holes for the slide brackets and cage nuts. If you prefer, mark all the cage nut positions on the rack at this time. c. Carefully remove the tape from the mounting rails, and attach the template to the rear mounting rails. Mark the locations for the slide brackets and cage nuts. Notes 1. You must align the slide brackets correctly, or the installation cannot be completed. 2. The slide rails have four screws each to allow for length adjustment. 2. Install the cage nuts in the marked positions as shown. 3. Attach the slide rail to the left side of the rack enclosure. 104 Netfinity Server HMM