IBM 86594RY Hardware Maintenance Manual - Page 77
Installing or removing drives in bays A and, B removable media, See Option installation
UPC - 087944479673
View all IBM 86594RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
3. Check the instructions that come with the drive if you need to set any switches or jumpers on the drive, or if you need to attach a tray to the drive. What to do next To install a removable-media drive, go to "Installing or removing drives in bays A and B (removable media)." To install a diskette drive, go to "Installing or removing a drive in bay C (diskette drive)" on page 70. To install a hard disk drive, go to "Installing or removing drives in bays 1 through 5 (hard disk drives)" on page 72. Installing or removing drives in bays A and B (removable media): This section gives the procedure for installing a removable-media drive. If you want to remove a drive, reverse the following steps. Before you begin Read "Safety information" on page 176. Read "Preinstallation steps (all bays)" on page 67 and the instructions that come with the option. Read "Termination requirements" on page 67 1. If you have not done so already, remove the server cover and the front bezel. See "Option installation" on page 125. 2. Remove the bay cover plate, if present. a. Remove the screws on either side of the cover plate that secure the plate to the target bay. b. Remove the cover plate from the server front panel. (Save the cover plate for future use.) 3. Using the instructions that come with the drive, together with these instructions, check that any switches or jumpers on the drive are set correctly. Change the settings if necessary. For information about termination requirements, see "Termination requirements" on page 67. 4. Position the drive with the connectors facing the rear of the server. Netfinity 5000 - Type 8659 69