IBM 8840 Installation Guide - Page 18

Features, specifications - hyper v

Get IBM 8840 - eServer xSeries 346 PDF manuals and user guides
UPC - 000435863799
View all IBM 8840 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Features and specifications The following information is a summary of the features and specifications of the server. Depending on the server model, some features might not be available, or some specifications might not apply. Racks are marked in vertical increments of 1.75 inches. Each increment is referred to as a unit, or "U." A 1-U-high device is 1.75 inches tall. Table 1. Features and specifications Microprocessor: Hot-swap power supplies: Acoustical noise emissions: v Intel® Xeon 2.8 GHz or higher v Declared sound power, idle: 6.6 bel depending on server model 625 watts (100-240 V ac) v Declared sound power, operating: 6.6 bel v 800 MHz front-side bus (FSB) v Minimum: One v Support for up to two microprocessors v Maximum: Two - provide redundant Heat output: with Intel Hyper-Threading Technology Note: Use the Configuration/Setup Utility program to determine the type and speed of the microprocessors. Memory: v Minimum: 512 MB power Size (2 U): v Height: 85.4 mm (3.36 in.) v Depth: 702 mm (27.64 in.) v Width: 443.6 mm (17.5 in.) v Weight: approximately 21.09 kg (46.5 lb) to 29.03 kg (64 lb) depending upon Approximate heat output in British thermal units (Btu) per hour: v Minimum configuration: 1230 Btu (360 watts) v Maximum configuration: 2840 Btu (830 watts) v Maximum: 16 GB v Type: 2-way interleaved PC2-3200, ECC DDR II SDRAM, registered DIMMs only v Sizes: 256 MB, 512 MB, 1 GB, or 2 GB Drives: v Diskette: 1.44 MB v DVD-ROM: IDE Expansion bays: v Six hot-swap, 3.5-inch drive bays (hot-swap hard disk drives installed, some models) configuration Integrated functions: v Baseboard management controller v Two Broadcom 10/100/1000 Ethernet controllers (dual-port design) with Wake on LAN® support v One serial port v One external and one internal Ultra320 SCSI port (dual-channel controller with integrated RAID) v Three Universal Serial Bus (USB) v1.1 or v2.0 ports Electrical input: v Sine-wave input (50-60 Hz) required v Input voltage range automatically selected v Input voltage low range: - Minimum: 100 V ac - Maximum: 127 V ac v Input voltage high range: - Minimum: 200 V ac - Maximum: 240 V ac v Input kilovolt-amperes (kVA) approximately: - Minimum: 0.36 kVA - Maximum: 0.83 kVA v One 5.25-inch bay (DVD-ROM drive Note: The baseboard management installed) controller is also known as the service v One 3.5-inch removable-media drive bay processor. (diskette drive installed) Notes: 1. Power consumption and heat output vary depending on the number and type Expansion slots: v Two PCI-X non-hot-plug 100 MHz/64-bit (low profile) v Two PCI-X non-hot-plug 133 MHz/64-bit Video controller: v ATI Radeon 7000M IGP video on system board v Compatible with SVGA and VGA v 16 MB DDR-SDRAM video memory of optional features installed and the power-management optional features in use. 2. These levels were measured in controlled acoustical environments Hot-swap fans: v Standard: Six v Maximum: 12 - provide redundant cooling Environment: v Air temperature: - Server on: 10° to 35°C (50.0° to 95.0°F); altitude: 0 to 914.4 m (3000 according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a ft) Decrease system temperature by given location might exceed the average 0.75°C for every 1000 feet increase values stated because of room in altitude. reflections and other nearby noise - Server off: 10° to 43°C (50.0° to sources. The declared sound-power 109.4°F); maximum altitude: 2133 m levels indicate an upper limit, below (7000 ft) which a large number of computers will - Shipment: -40° to 60°C (-40.0° to operate. 140°F); maximum altitude: 2133 m (7000 ft) v Humidity: - Server on/off: 8% to 80% - Shipment: 5% to 100% 4 IBM xSeries 346 Type 8840: Installation Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
Features
and
specifications
The
following
information
is
a
summary
of
the
features
and
specifications
of
the
server.
Depending
on
the
server
model,
some
features
might
not
be
available,
or
some
specifications
might
not
apply.
Racks
are
marked
in
vertical
increments
of
1.75
inches.
Each
increment
is
referred
to
as
a
unit,
or
“U.”
A
1-U-high
device
is
1.75
inches
tall.
Table
1.
Features
and
specifications
Microprocessor:
v
Intel
®
Xeon
2.8
GHz
or
higher
depending
on
server
model
v
800
MHz
front-side
bus
(FSB)
v
Support
for
up
to
two
microprocessors
with
Intel
Hyper-Threading
Technology
Note:
Use
the
Configuration/Setup
Utility
program
to
determine
the
type
and
speed
of
the
microprocessors.
Memory:
v
Minimum:
512
MB
v
Maximum:
16
GB
v
Type:
2-way
interleaved
PC2-3200,
ECC
DDR
II
SDRAM,
registered
DIMMs
only
v
Sizes:
256
MB,
512
MB,
1
GB,
or
2
GB
Drives:
v
Diskette:
1.44
MB
v
DVD-ROM:
IDE
Expansion
bays:
v
Six
hot-swap,
3.5-inch
drive
bays
(hot-swap
hard
disk
drives
installed,
some
models)
v
One
5.25-inch
bay
(DVD-ROM
drive
installed)
v
One
3.5-inch
removable-media
drive
bay
(diskette
drive
installed)
Expansion
slots:
v
Two
PCI-X
non-hot-plug
100
MHz/64-bit
(low
profile)
v
Two
PCI-X
non-hot-plug
133
MHz/64-bit
Hot-swap
fans:
v
Standard:
Six
v
Maximum:
12
-
provide
redundant
cooling
Hot-swap
power
supplies:
625
watts
(100-240
V
ac)
v
Minimum:
One
v
Maximum:
Two
-
provide
redundant
power
Size
(2
U):
v
Height:
85.4
mm
(3.36
in.)
v
Depth:
702
mm
(27.64
in.)
v
Width:
443.6
mm
(17.5
in.)
v
Weight:
approximately
21.09
kg
(46.5
lb)
to
29.03
kg
(64
lb)
depending
upon
configuration
Integrated
functions:
v
Baseboard
management
controller
v
Two
Broadcom
10/100/1000
Ethernet
controllers
(dual-port
design)
with
Wake
on
LAN
®
support
v
One
serial
port
v
One
external
and
one
internal
Ultra320
SCSI
port
(dual-channel
controller
with
integrated
RAID)
v
Three
Universal
Serial
Bus
(USB)
v1.1
or
v2.0
ports
Note:
The
baseboard
management
controller
is
also
known
as
the
service
processor.
Video
controller:
v
ATI
Radeon
7000M
IGP
video
on
system
board
v
Compatible
with
SVGA
and
VGA
v
16
MB
DDR-SDRAM
video
memory
Environment:
v
Air
temperature:
–
Server
on:
10°
to
35°C
(50.0°
to
95.0°F);
altitude:
0
to
914.4
m
(3000
ft)
Decrease
system
temperature
by
0.75°C
for
every
1000
feet
increase
in
altitude.
–
Server
off:
10°
to
43°C
(50.0°
to
109.4°F);
maximum
altitude:
2133
m
(7000
ft)
–
Shipment:
-40°
to
60°C
(-40.0°
to
140°F);
maximum
altitude:
2133
m
(7000
ft)
v
Humidity:
–
Server
on/off:
8%
to
80%
–
Shipment:
5%
to
100%
Acoustical
noise
emissions:
v
Declared
sound
power,
idle:
6.6
bel
v
Declared
sound
power,
operating:
6.6
bel
Heat
output:
Approximate
heat
output
in
British
thermal
units
(Btu)
per
hour:
v
Minimum
configuration:
1230
Btu
(360
watts)
v
Maximum
configuration:
2840
Btu
(830
watts)
Electrical
input:
v
Sine-wave
input
(50-60
Hz)
required
v
Input
voltage
range
automatically
selected
v
Input
voltage
low
range:
–
Minimum:
100
V
ac
–
Maximum:
127
V
ac
v
Input
voltage
high
range:
–
Minimum:
200
V
ac
–
Maximum:
240
V
ac
v
Input
kilovolt-amperes
(kVA)
approximately:
–
Minimum:
0.36
kVA
–
Maximum:
0.83
kVA
Notes:
1.
Power
consumption
and
heat
output
vary
depending
on
the
number
and
type
of
optional
features
installed
and
the
power-management
optional
features
in
use.
2.
These
levels
were
measured
in
controlled
acoustical
environments
according
to
the
procedures
specified
by
the
American
National
Standards
Institute
(ANSI)
S12.10
and
ISO
7779
and
are
reported
in
accordance
with
ISO
9296.
Actual
sound-pressure
levels
in
a
given
location
might
exceed
the
average
values
stated
because
of
room
reflections
and
other
nearby
noise
sources.
The
declared
sound-power
levels
indicate
an
upper
limit,
below
which
a
large
number
of
computers
will
operate.
4
IBM
xSeries
346
Type
8840:
Installation
Guide