IBM 8863 User Manual - Page 33
Installing, ServeRAID-8i, hot-plug, adapter
![]() |
UPC - 000435474667
View all IBM 8863 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Installing a ServeRAID-8i If you are installing an optional ServeRAID-8i, review the following information: v The ServeRAID-8i can be installed only in a dedicated slot on the PCI-X board. v The ServeRAID-8i adapter is not cabled to the server and no rerouting of the SAS cables is required. v The blue handle that comes with the adapter is required to install the adapter. The following illustration shows how to install a ServeRAID-8i adapter. ServeRAID-8i adapter ServeRAID-8i slot DCAC For more detailed instructions or information, see the User's Guide on the IBM xSeries Documentation CD. Installing a hot-plug adapter Attention: Static electricity that is released to internal server components when the server is powered-on might cause the server to halt, which could result in the loss of data. To avoid this potential problem, always use an electrostatic-discharge wrist strap or other grounding system when working inside the server with the power on. To install a hot-plug PCI or PCI-X adapter, complete the following steps. Note: For hot-pluggable adapters, make sure that the PCI hot-plug device driver is installed. For details, see the documentation that comes with the adapter. For more detailed instructions and information about installing PCI/PCI-X adapters, see the section about installing options in the User's Guide on the IBM xSeries Documentation CD. Chapter 2. Installing options 21
![](/manual_guide/products/ibm-88632ru-user-manual-05f8a35/33.png)